If-10C Interface Kit Installation - Kenwood TS-680S Instruction Manual

7-3. IF-10C INTERFACE KIT INSTALLATION §. Attach the DIN connector from the IF-10C with
the supplied bracket and mounting screws. Lay
1. Remove the bottom cover of the transceiver. a
the wiring along the back of the set.
Please refer to Section 6-6-1.
2. Install the IF-10C in the upper left of the contral
unit with the 4 screws provided with the IF-10C.
Ensure the unit is properly positioned as shown in
the diagram.
6. Reinstall the bottom cover.
Note: nao
Do not pinch any cable harnesses when reas-
sembling.
3. Insert the 7 and 9 pin connectars from the IF-10C
onto connectors CN8 and CNS near the center of
the contral unit. Lay the wiring alang the hack of
the set.
4, Remove the black filler from the ACC1 area on the
back of the transceiver.
a es
>
36