Accessories - Kenwood TS-680S Instruction Manual

Specifications ne Model Ts-1408 Ts-6808
| circuitry : Double conversion superheterodyne
" Frequency range 500 kHz to 30 MHz ane a 2 we
intermediate frequency 1st: 40.055 MHz, 2nd: 455 kHz
I 800 kH? to 1.6 MHz "Less than 3.98 nV
| LSB, USB, CW [1.6 MHz to 21.5 MHz ____Less than 0.26 wv
| fat 10 dB S+N/N) [21.6 MHz to 30 MHz | Less than 0.25 xV_| Less than 0.18 pV »2
i 60 MHzta54MHz |) Less than 0.16 pV +2
_ [ 600 kHz to 1.6 MHz Less than 39.8 pV ~
Sensitivity AM 1.6 Mez to 21.5 Miz Less than 2.5 nV
| (at 10.d8S+N/N) | 21.5 MHz to30 MHz | Less than 2.5 .V_| Less than 1.78 pV «2
. | 50 MHz to 54 MHz = Less than 1.58 xV «2|
2) FM 21.5 MHz to 30 MHz_| Less than 0.35 »V_| Less than 0.18 pV «2
ce (at 12 dB SINAD) ~— | 50 MHz to 54 MHz — Less than 0.18 pV +2
; LSB, USB, CW 6 dB: 2.2 kHz, —60 dB: 4.4 kHz
Selectivity 7 AM =6 dB: 6 kHz, —50 dB: 18 kHz
— FM i —6 dB: 12 kHz, — 50 dB: 25 kHz
Image ratia More than 50 dB
—— ae |
Ist IF rejection More than 50 dB
IF SHIFT variable range More than +1.2 kHz
~ 10 Hz STEP "More than £ 1.2 kH?
RIT variable range a
po nse 20 Hz STEP More than *2.5 kHz
Squelch sensitivity (EM) Less than 0.32 4V
' Output 1.5 W across 8 ohms load (10% distortion)
Output load impedance _ 7 _ 8 ~ 16 ohms
Notes: - soe n=:
1. *1: The output power on the 160 m band is limitted to 10 W depending on local regulations.
2. *2: This is valuable when the RF AMP switch is turned ON.
3. Circuit and ratings are subject to change without notice due to advancements in technology.
2-2. ACCESSORIES
Unpack your TS-140S/680S carefully and confirm that it is supplied with the following accessories.
Dynamic microphone (Except European and U.K. version) .191-0352-05.. ea.
DIN plug (7-pin) -E07-0751-05 ea.
DIN plug (13-pin). -E07-1351-05 ea.
DC power cable assembly -E30-2065-05 ea.
Calibration cable. -E31-2154-05 ea.
Fuse (20A).... -FO5-2036-05 .. ea.
Instruction manual -B50-8199-XX . copy
Warranty card... ea.
After unpacking
Shipping container:
Save the boxes and packing in the event your unit needs to be transported for remote operation, maintenance, or
service.