Installation; Front Panel - Kenwood TS-130SE Instruction Manual

2.2 ACCESSORIES
DC power cord (E30-1638-05)..........000ccccccceeseeeees 1
Fuse, 20A (FO5-2034-05)
Instruction manual (B50-3954-00)
2.3 INSTALLATION
It is preferable to choose an operating location that is dry
and cool, and to avoid operating the transceiver in direct
AANA AUREL -aRDEDD.00UD 4HUHD ANNA eHNEES-AEEE-cH
Suver-sene-connen-canate-cneenesennnts-a
STS Ee et et ee eee
SECTION 3.
sunlight.
Allow adequate ventilation, particularly during mobile opera-
tion.
NOTE: —— moe
The TS-130SE is supplied to receive on the following
frequencies (transmission is disabled):
10 MHz band (10.0— 10.25 MHz)
18 MHz band (18.0— 18.5 MHz)
24.5 MHz band (24.5 —25.0 MHz)
ee sennnt 0
CONTROLS
@® ANTI VOX CONTROL
@) DELAY CONTROL
@) VOX GAIN CONTROL:
@ SUBDIAL
@ METER
@ DIGITAL DISPLAY
® STANDBY SWITCH
(MODE SWITCH
®© MIC CONNECTOR
@© PHONES JACK:
@ PROC SWITCH
VOX SWITCH
@ METER SWITCH
@ FIX SWITCH
(2 MAIN TUNING CONTROL
Q) FIX INDICATOR
G0) VOX INDICATOR
(9 RIT INDICATOR
(® CARRIER LEVEL CONTROL
(() MIC CONTROL
QM RF GAIN CONTROL
(8) AF GAIN CONTROL
(@ IF SHIFT CONTROL
(@) BAND SWITCH
(5 RIT CONTROL
@) POWER SWITCH
— NOISE BLANKER SWITCH
@) RF ATT(RF ATTENUATOR) SWITCH
@) NAR WIDE SWITCH
3.1 FRONT PANEL
@ METER
The meter has three functions, two being selected by the
@) RIT SWITCH
Fig. 3-1 Front Panel
FBV! 0 csc ucees
During SSB operation, this position selects
the reverse side band: from USB to LSB or
vice versa.
CW dccqece
Used for CW operation.
METER switch. In receive the meter is automatically an S-
meter showing receive signal strength on a scale of 1 ~ 9,9
+ 20, + 40 and + 60 dB. In transmit. the meter shows
Ic or ALC level, depending on METER switch position.
@ DIGITAL DISPLAY
The digital display indicates true operating frequency to an
accuracy of 100 Hz.
@ MODE SWITCH
SSB... sats Permits SSB operation. LSB is normally
selected for opration on the 3.5 and 7 MHz
bands, and USB for operation on and above
the 10 MHZ bands.
Switching between LSB and USB is done
automatically by the BAND switch.
@ STANDBY SWITCH
© MIC CONNECTOR