Kenwood TK-261 Instruction Manual page 17

1 Switch OFF the transceiver.
2 Press and hold [PTT] and [LOW], then switch ON the
transceiver.
3 Turn the CHANNEL selector to choose the channel.
4 Press [MONI] repeatedly until you select the desired
code.
e Adifferent beep sequence sounds each time you select a
new code. The parentheses shown under selection Nos.
designate newly selected codes, assuming you selected
channel 2.
1-long beep &
2 short beeps
1 long beep & 1 long beep &
3shortbeeps 4 short beeps
5 Press [LOW] to complete the setting.
6 Switch the transceiver OFF then ON to use the new
settin
1 short beep