Philips 6000 Series Instructions Manual page 13

• Connect the power cord
• Addition of clean water: Take out the water tank from the docking station, open the lid on the water
filling port, add clean water into the tank via the filling port, and put back the water tank into the station.
Note: When adding water, please pay attention to the capacity of the water tank to prevent overfilling.
Close up the lid tightly after adding water.
Do not fill the water tank with cleaning fluids. Do not fill the water tank with other cleaning fluids,
disinfectants, or additives, otherwise serious damage may be caused to the robot and the docking station.
Such damage will be considered as "manual damage caused by improper use" and shall not be covered by
the free warranty.
Do not fill the water tank with hot water (above 60°C).
• Take out the protective strip of the main unit: Take out the protective strip of the cushion bumper of
the main unit before use.
Note: Take off the transparent protective sticker on the cushion bumper before use and tear down the
transparent anti-scratch sticker from the docking station.
13
English