Operating Controls - Philips AROFLEX CRYPTO EQUIPMEN UA8116 Series Operating Instructions Manual

RESTRICTED
Section 2
Operating controls
The position numbers in the first column, and in parentheses in the
text, refer to figure 3.
Pos
1
Name
LINE button
OFF-LINE button
Function
Spring-loaded button for connecting AROFLEX to the line, starting
from the standby mode.
No function in the OFF-LINE mode.
Flashing lamp inside button indicates end of paper roll.
Spring-loaded button for putting AROFLEX into the OFF-LINE
mode, starting from the standby mode. Lamp is lit when AROFLEX
is in the OFF-LINE mode.
OUT button
Spring-loaded button for putting AROFLEX into the standby mode
from either the line-connected mode or the OFF-LINE mode. Lamp
inside button is lit when AROFLEX is in the line-connected mode.
PUNCH STANDBY
Spare button, to be used for telex networks etc.
Spare button, to be used for telex networks etc.
Two-position button for putting the tape punch into the standby mode
for line-connected operation so that all incoming traffic is punched
and printed.
Depressed position is the PUNCH STANDBY position.
PROCEDURE button
Two-position button for starting and terminating the enciphering
process.
When the button is pushed down, the red lamp inside the button
is lit and AROFLEX is ready to carry out the crypto procedure as
described in paragraph 4.5.1.
After the crypto procedure the clear text heading of Format Lines
1 ... 4 (if required) may be put in, without counting Line Feeds.
Lit lamp denotes PROCEDURE mode.
Releasing the button terminates the enciphering process.
RESTRICTED