Philips AROFLEX CRYPTO EQUIPMEN UA8116 Series Operating Instructions Manual page 28

RESTRICTED
25
To terminate enciphering and
add clear text (Format Lines
14 and 15) after cryptogram,
press PREAMBLE button (8).
If Lines 14 and 15 are not
required, proceed to Step 10.
Lamps light inside PROC and PRE
AMBLE buttons; lamp in ENCI
button is extinguished. AROFLEX
prints 10 slants (III I III III) on new
line and stores enciphered serial
number of key (or ZZZZZ), BT and
group count.
Type clear text of Lines 14
and 15
AROFLEX prints and stores clear
text.
NOTE
If termination of enciphering was enforced (see Note (2) above)
approximately 100 characters are available for Lines 14 and 15.
10. Release PROC button If AROFLEX was in PREAMBLE
mode (Steps 8 and 9), lamps in
PROC and PREAMBLE buttons are
extinguished; AROFLEX generates
8x LF, NNNN
If AROFLEX was in ENCI mode,
lamp in ENCI button is exting
uished; AROFLEX prints 10 slants
(III III III I) on new line and stores
enciphered serial number of key
(or ZZZZZ), BT and group count.
AROFLEX then generates 8 x LF,
NNNN.
11. Press tape punch on/off
button (15) and OUTPUT
button (10)
Lamp lights in OUTPUT button.
AROFLEX prints/punches crypto
gram, complete with heading, End
of Message, and clear text of Format
Lines 14 and 15 (if entered).
RESTRICTED