Table of Contents
Advertisement
| Motor) ilelaw-laleM mUlaveiitelame)m@relalinze)
Front panel
Each button or switch (except POWER) is equipped with an
indicator which lights up when turned on. To turn the
indicator off, simply press it again.
(23;
|22|
[13] [12!
7
16 [15] '14
1, POWER switch
INPUT SELECT buttons
Select the desired input source.
Two video and audio
channels 1 and 2, are available.
On each channel, S-
VIDEO selects the VCR connected to the S-VIDEO
SOURCE
IN, and VIDEO selects the VCR connected to
the V SOURCE IN connector.
GAMMA control
Adjusts the luminous intensity and color signals to give
the recorded object a suitable brightness.
HUE control
Adjusts the hue.
COLOR control
Adjusts the color intensity.
BYPASS switch
Outputs unprocessed video signals.
'SPLIT SCREEN switch
Divides the screen to display the processed video
image on the left half and the unprocessed video image
on the right.
VIDEO ART REVERSE switch
' Selects where to start painting the image, from either
high (off) or low (on) luminance portions of the image.
9 | VIDEO ART control
Controls the painting of the video image with color
selected by the COLOR SELECT knob.
To use the
videu art function, set the WIPE lever all the way up and
operate this control.
This control should normally be set to the rightmost
(maximum) position, otherwise the wipe will not
function.
|
;10; CHROMA
NR (noise reduction) switch
"Reduces color flickers in the image.
41 | REVERSE (NEGA/POSI) switch
Inverts the output signal.
12 Fader VIDEO button
Enables video fade in/out using the FADER lever.
|13| Video fader WHITE/BLACK/BACK COLOR buttons
Selects either white, black or the back color designated
by the COLOR SELECT knob as the fader color.
(Default selection is white.)
14 Fader AUDIO button
Enables audio fade in/out using the FADER lever.
|15| COLOR SELECT knob
Selects a color for wipe and video fader.
Advertisement
Table of Contents
