Important Instructions F Or Your Safety - Kenmore 911.9554591 Owner's Manual

iMPORTANT iNSTRUCTIONS F OR YOUR SAFETY
Result i!!ii!i
*Install Anti-tip Device ilii
Packed With Range i_!:_i
° See installation Instructions .......
Tools you will need:
Phillips head screwdriver
1 3/8" open end or adjustable wrench
I. Remove the bracket from the prepack
located inside the oven_
2. Decide whetherthe bracketwifl be installed
on the right or left side of range location
3. If the bracket side of the range is adjacent
to a cabinet, place the bracket against
back wall and cabinet as shown below
ADJACENT CABINET OR FINAL
LOCATION OF RANGE SIDE
PANEL
OUTSIDE EDGE OF
BRACKET TO BE
FLUSH WITH LEFT OR
Jj_IGHT
SIDE OF_NGE
\lt_J WALL BEHIND
.2 _,_ RANGE t
" ".\\ /
3
4_
m
6.
7.
If there is no adjacent cabinet, determine
where the location of the range side (painted
outside panel) wilt be., Place the bracket
with its outside edge at this location and
against back wall See illustration below,
Determine whether ,you will anchor the
bracket to the floor or wall Make sure this
location is clear of electrical wiring or
plumbing.,
Fasten the bracket securely with the screws
provided, Screws are self-drilling in wood,
p!ywood, particle and chip board, and
most metal framing, If attaching to
masonry, you can buy suitabfe screws and
anchors at hardware stores Use a masonry
drill to drill the required holes
BRACKET
N
SCREW MUST ENTER X_k -
WOOD OR METAL |
/
WALL
PLATE
/
ATTACHMENTTO WALL
Using the wrench, back out the four leg
levelers at least two turns See .your
installation guide for more leveling
information before positioning range,
Slide the range into place, Be sure rear leg
leveler fuffy engages the stotin the bracket, ff
range cannot be moved back far enough
for rear leg leveler to enter bracket, move
bracket forward as required and attach to
floor in new location