Operation; Removing The Vacuum Cleaner From The Standard Wall Bracket; Removing The Vacuum Cleaner From The Speedlock Wall Bracket; Switching On And Off - Miele HS23 Operating Instructions Manual

en

Operation

Removing the vacuum cleaner from
the standard wall bracket (Fig. 26)
 Remove the vacuum cleaner from the
wall bracket by pulling it upwards.
Removing the vacuum cleaner from
the SpeedLock wall bracket
(Fig. 27 + 28)
 Remove the vacuum cleaner from the
wall bracket by pulling it forwards
(Fig. 27).
The SpeedLock wall bracket offers the
option of using the PowerUnit con-
veniently as a PowerUnit solo, without
having to release it manually from the
suction tube.
 Pull the PowerUnit upwards out of the
wall bracket guide (Fig. 28).
The suction tube and the electrobrush
stay in the wall bracket.
Switching on and off (Fig. 29)
 If you have charged the battery dir-
ectly, pull the charging plug out of the
charging socket on the bottom on the
rear of the PowerUnit.
For the best possible cleaning results,
always start the ComfortClean self-
cleaning function before switching on
the vacuum cleaner (see "Cleaning
and care" – "Activating the Comfort-
Clean self-cleaning function").
 Press the upper button on the
handle .
The vacuum cleaner will switch on us-
ing the lowest power level.
54
Increasing the suction power (Fig. 30)
 Press the lower button on the handle.
The higher power level is selected and
the LED lights up.
Press the button again to return to the
lower power level.
Using the PowerUnit solo (Fig. 31)
The PowerUnit can be used on its own
without the suction tube and electro-
brush as a quick way of vacuuming up
crumbs and fluff in specific areas.
Tip: This configuration is particularly
suitable when using the three-piece ac-
cessory set (see "Using the accessories
included").