Charging The Battery (With Wall Mounting); Screwing The Wall Bracket To The Wall; Attaching The Charging Cable To The Standard Wall Bracket; Attaching The Charging Cable To The Speedlock Wall Bracket - Miele HS23 Operating Instructions Manual

Charging the battery (with wall
mounting)
You will need a suitable location near
a free power socket for mounting the
appliance on the wall.
Depending on the model, the scope of
delivery of your vacuum cleaner in-
cludes one of the following wall brack-
ets.
Standard wall bracket (Fig. 07)
SpeedLock wall bracket (Fig. 08)
Before charging the battery for the first
time, you must read the information in
"Commissioning" – "General battery
information".

Screwing the wall bracket to the wall

(Fig. 09, 10 + 11)
2 plugs and 2 T20 TORX screws are
supplied for attaching the wall bracket.
You will also need a battery-operated
screwdriver or a drill (with a drilling dia-
meter of 6 mm).
Depending on the wall bracket, select a
distance of 106 cm (standard wall
bracket) or 96 cm (SpeedLock wall
bracket) between the bottom edge of
the wall bracket and the floor (Fig. 09).
You will need a suitable location near
a free power socket for mounting the
appliance on the wall.
Be careful not to damage any cables
laid in the wall.
 Attach the standard wall bracket (Fig.
10) or the mounting plate of the
SpeedLock wall bracket (Fig. 11) to
the wall.
Attaching the charging cable to the
standard wall bracket (Fig. 12 + 13)
 Push the charging plug of the char-
ging cable through the wall bracket
from below.
 Plug the charging plug into the plug
holder and press it in firmly (Fig. 12).
 Slide the cover down into the wall
bracket from above until it audibly
clicks into place (Fig. 13).
The charging cable is held securely in
the wall bracket.
 Place the vacuum cleaner into the
wall bracket from above (Fig. 07).
 Plug the charger into the power
socket.
The charging process will start.
Attaching the charging cable to the
SpeedLock wall bracket
(Fig. 14, 15 + 16)
A cable guide is located on the rear of
the wall bracket.
 Plug the charging plug of the char-
ging cable firmly into the socket (left
part of the image).
 Lay the charging cable in its guide
(right part of the image) (Fig. 14).
 Push the wall bracket down into the
mounting plate from above until it
audibly clicks into place (Fig. 15).
The charging cable is held securely in
the wall bracket.
 Place the vacuum cleaner into the
wall bracket making sure it fits prop-
erly (Fig. 16).
en
51