Installing The Lower Triple Clamp; (All Six Days Models) - Husqvarna 125 XC-W 150 2017 Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.12

Installing the lower triple clamp

(All Six Days models)

Main work
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
–
Check whether upper steering head seal
–
Mount protective ring
B01218-10
–
Position the upper triple clamp with the handlebar.
–
Mount screw
–
Position the clutch line and wiring harness.
V00356-10
–
Position the fork legs.
Bleeder screws
Info
The rebound damping is located in right fork leg REB (red adjusting screw).
The compression damping is located in left fork leg COMP (white adjusting
screw).
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
H01637-10
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
V00353-10
–
Tighten screw
Guideline
Screw, top steering head
V00360-10
p. 143)
 and O-ring 

but do not tighten yet.

are positioned toward the front.

.

.

.

is correctly positioned.
.
M8 17 Nm
(12.5 lbf ft)
M8 15 Nm
(11.1 lbf ft)
M20x1.5 12 Nm (8.9 lbf ft)
57