12
SERVICE WORK ON THE CHASSIS
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
V00338-10
–
Tighten screw
Guideline
Screw, top steering head
V00337-10
–
Tighten screw
Guideline
Screw, top steering stem
V00337-11
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front brake caliper
–
Mount the cable tie(s).
–
Position the brake line, wiring harness, and clamp. Mount and tighten screws
E00375-12
Finishing work
–
Mount the handlebar cushion.
–
Install the front fender. (
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check that the wiring harness, throttle cables, and brake and clutch lines can move
freely and are routed correctly.
–
Check the play of the steering head bearing. (
–
Remove the motorcycle from the lift stand. (
–
Check the headlight setting. (
.
.
.
.
M8
p. 60)
(
p. 85)
p. 97)
M8
20 Nm
(14.8 lbf ft)
M8
15 Nm
(11.1 lbf ft)
M20x1.5
12 Nm (8.9 lbf ft)
M8
20 Nm
(14.8 lbf ft)
.
25 Nm
Loctite
(18.4 lbf ft)
p. 95)
p. 58)
p. 51)
56
®
243™
.