Accessories - Kenwood TS-140S Instruction Manual

Specifications ae TS-1408 TS-G508
Circuitry Double conversion superheterodyne
Frequency range 500 kHz to 30 MHz ae ivi s Sas
Intermediate frequency 1st: 40.055 MHz, 2nd: 455 kHz
500 kHz to 1.6 MHz Less than 3.98 pV
LSB, USB, CW 1.6 MHz to 21.5 MHz Less than 0.25 pV
(at 10 dB S+N/N) 21.5 MHz to 30 MHz Less than 0.25 pV | Less than 0.18 pV «2
50 MHz to 54 MHz Less than 0.16 pV «2
ee 500 kHz to 1.6 MHz Less than 39.8 pV
Sensitivity Ash 1.6 MHz to 21.5 MHz Less than 2.5 nV
(at 10 dB S+N/N) 21.5 MHz to 30 MHz Less than 2.5 yV | Less than 1.78 pV +2
re 50 MHz to 54 MHz Less than 1.58 pV «2
2 FM
21.5 MHz to 30 MHz | Less than 0.35 »V_|
Less than 0.18 pV +2
& (at 12 dB SINAD) | 50 MHz to 54 MHz — Less than 0.18 pV +2
LSB, USB, CW —6 dB: 2.2 kHz, —60 dB: 4.4 kHz
Selectivity AM —6 dB: 6 kHz, —50 GB: 18 kHz
FM —6 dB: 12 kHz, —50 dB: 25 kHz
Image ratio More than 50 dB
1st IF rejection More than 50 dB
IF SHIFT variable range More than +1.2 kHz
10 Hz STEP More than +1.2 kHz
RIT variable range
20 Hz STEP More than +2.5 kHz
Squelch sensitivity (FM) Less than 0.32 pV
Output 1.5 W across 8 ohms load (10% distortion)
Output load impedance 8 ~ 16 ohms
Notes:
1. *1: The output power on the 160 m band is limitted to 10 W depending on local regulations.
2. *2: This is valuable when the RF AMP switch is turned ON.
3. Circuit and ratings are subject to change without notice due to advancements in technology.
2-2. ACCESSORIES
Unpack your TS-140S/680S carefully and confirm that it is supplied with the following accessories.
Dynamic microphone (Except European and U.K. version) .
DIN plug (7-pin).......
DIN plug (13-pin).....
DC power cable assembly
Calibration cable
Fuse (20A)
Instruction manual...
..-E30-2065-05 .
T91-0352-05....
E31-2154-05....
FO5-2036-05....
B50-8199-XX ...
copy
Warranty Card itis str atean sa Peete Reah ok pine nas can den seo sasacaacenad paged sc asdesnasasatsdgnadesve edo centiesaeuaasbeeeenets ss sales ea.
After unpacking
Shipping container:
Save the boxes and packing in the event your unit needs to be transported for remote operation, maintenance, or
service.