Sharp QA1150 Operation Manual page 15

6) Composite video input connection
Connect the composite video signal cable to the composite video input connector. Then
press the PC/VIDEO button on the remote control unit to switch between the computer
video output and the composite video signal.
The unit supports the following video signal standards, and automatically switches
between NTSC and PAL: system M (NTSC), systems B, G, H and I (PAL).
Adjusting the video image
The video adjustments are preset at the factroy and should not require any adjustment. If
adjustment is required, please use the adjustment tool supplied.
Insert the slotted end of the tool into the control to be adjusted.
Turn the knobs to obtain the most satisfactory result.
@® BRIGHT adjustment
This adjusts the brightness of the image.
Turn it clockwise to increase image brightness.
Turn it counterclockwise to decrease image brightness.
@ COLOR adjustment
This adjusts the color saturation of the image.
Turn it clockwise to increase color.
Turn it counterclockwise to decrease color.
@ TINT adjustment
This adjusts the hue of the image. Set it so that flesh tones look natural.
Turn it clockwise to make the hue more green.
Turn it counterclockwise to make the hue more purple.
SERIAL COMPUTER MONITOR VIDEO COLOR BRIGHT TINT REAR FRONT
bey
Video adjustment tool
\ Color adjustment — Brightness
: / : ;
\ adjustment Tint adjustment
/
>
a f= Seven
VS
Composite video signal cable
To VCR
13