Remote Control Numbering Function - Mitsubishi Electric LM55S1 User Manual

Other functions (continued)
By connecting multiple LM55S1 (W) monitors using RS-232C cables, you can control any one monitor or all the monitors by one
remote controller.
NOTE:
• You cannot use the remote control numbering function if monitors are multi-connected using REMOTE IN/OUT.
1. Assign arbitrary ID number to each of multi-connected LM55S1 (W) monitors using MONITOR ID.
You can set 1 to 26 for a monitor ID of LM55S1 (W) that is intended to set as PRIMARY.
You can set 1 to 104 for a monitor ID of LM55S1 (W) that is intended to set as SECONDARY.
While you are setting a MONITOR ID, leave the remote control mode as NORMAL.
It is recommended to assign sequential ID numbers from 1 and up.
2. The remote control mode of the fi rst LM55S1 (W) monitor is set to PRIMARY and those of the other monitors are set to
SECONDARY.
3. When you direct the remote controller at the remote control signal sensor of the PRIMARY monitor and press the DISPLAY
button on the remote controller, the ID selection OSD appears at the upper left of the screen.
ID:1
ID No. :2
4. Direct the remote controller at the remote control signal sensor of the PRIMARY monitor.
OSD appears on the monitor having the ID number you selected.
NOTE:
When the ID selection OSD is being displayed on the PRIMARY monitor, press the DISPLAY button on the remote controller again to
cancel the ID selection OSD and then control the monitor you selected.
Do not send the control command from the computer and operate the remote control at the same time. Failure to do so may cause
improper operation of the LCD monitor.
If you set the remote control mode wrongly and remote control operation becomes unavailable, press any button on the control
panel of the monitor to display the OSD screen and change the remote control mode using ADVANCED OPTION. By pressing and
holding down the DISPLAY button on the remote control for 8 seconds or longer, the remote control mode is initialized to NORMAL.

Remote control numbering function

ID number of the currently viewed monitor
Select the ID number of the monitor you want to control using the +/- button on the remote controller.
The ID of the monitor you want to control is displayed at the upper left of its screen.
By selecting ALL, you can control all the multi-connected monitors.
English-57