Table of Contents
Advertisement
6.3
Compressor
The compressor (16) is driven by 1.5 kW electromotor (15). Refer to fig. on page 36.
Clean the air filter (17) of the compressor every month. Only use air to clean the air filter. Replace the air filter
at least once every year or 3000 working hours (whichever comes first).
Do a check of the cooler (18) of the compressor and clean it at least once every year or 3000 working hours
(whichever comes first).
Do a check of the safety valve (19) at least once every year or 3000 working hours (whichever comes first).
17
If the compressor does not keep the required working pressure or becomes too hot, do a check of below parts:
•
Suction filter
•
Rotating direction
•
Dirty cooling ribs
•
Valves and seals
•
Leaks in the system
•
Drain valve for water release
Before you remove any part of the compressor:
•
Make sure that the compressor cannot start.
•
Make sure there is no pressure in the system.
To clean or replace the filter cartridge, proceed as follows:
1. Remove cladding/cover.
2. Remove filter case cover
3. Take out the filter cartridge.
4. Clean/change filter cartridge.
To clean the filter cartridge:
1. Tap the filter cartridge with your hand to knock out coarse dust.
2. Remove the dust with dry compressed air (maximum pressure 5 bar) from the inside outwards.
3. Clean the sealing surfaces of the filter cartridge.
To insert the filter cartridge:
Insert the cleaned or new filter cartridge as follows:
1. Insert the filter cartridge into the filter case.
2. Fasten the filter case cover.
3. Fit the service side cladding.
For more information about the maintenance refer to the Boge manual.
21.07.2023
18
19
Suction filter and filter cartridge
37
Advertisement
Table of Contents
