Advertisement
CONTROLS AND INDICATORS
@ Listening to AM/FM
1. Press the Power switch to ON.
2. Press the TUNER
key of the input selector.
3. Select FM or AM of the band (FM/AM) selector.
4. Tune
to the required
station
with
following
proce-
dures: Auto tuning, Manual tuning or Direct tuning.
Auto tuning
1. Press
the
AUTO/MANUAL
(MONO)
key
to set
to
"AUTO".
2. Press the UP or DOWN TUNING key: The frequency will
automatically increase or decrease until a station with
sufficient signal level is received. To stop the frequency
scanning
before
a station
is received,
press
the
AUTO/MANUAL
key to set to "MANUAL".
3. Adjust the VOLUME
control to the required listening
level and use the graphic equalizer control to adjust the
sound to your own
preference.
Manual tuning
1. Press
the
AUTO/MANUAL
(MONO)
key to set
to
"MANUAL".
2. Press the UP/DOWN TUNING key to tune in the desired
Station.
To continuously increase or decrease frequencies, hold
the TUNNING
key depressed.
3. Adjust the VOLUME
control to the required listening
level and use the graphic equalizer control to adjust the
sound to your own preference.
Direct tuning
1. Select FM or AM with the FM, AM selector switch.
2. Press the DIRECT key.
3. Input the desired frequency with numeric keys.
4, The receiver enters the radio reception mode just after
the frequency value has been input.
(If the input value
is outside
the tuning
range, the
frequency display flashes for 5 seconds and the receiver
returns to the radio reception mode of the last channel.)
@ Presetting broadcast station data
In total up to 20 stations
data
(station
frequency
and
station name) can be stored in memory.
1. Select the desired station with either AUTO
tuning,
MANUAL
tuning or DIRECT tuning.
2. Input the broadcast station name
in accordance with
the character input procedure.
For the broadcast station names, up to 4 characters can
be input.
@ When the contents in item 2 is not required for display
memory. proceed to item 3 after item 1.
3. Press
the
preset
function
key to select
1-10"
or
"14-20".
4. Press
the
MEMORY
key. (The
MEMORY
indicator
lights.)
5. Press one of the numeric keys: The frequency being
tuned in and the station name are stored.
Character input procedure
1. Press the CHARACTER
button
to set the character
input mode. The first column of the character display
section begins flashing.
2. Press
the
TUNING
UP/DOWN
key
to select
the
character.
3. When
the desired
character is displayed, press the
DIGIT key.
Flashing will shift to the next column.
4. Repeat procedure 3 and 4 for four times to complete
inputting. The character input mode will be released.
@
Even in the middle of inputting. pressing the CHARAC-
TER key again will release the character input mode. At
this time, the data which has been input is valid.
Example 1: To preset the 91.50 MHz FM broadcast
and a station name
"W
N Y" when
the
station
other
than
the
preset
channel
memories is received.
1. Tune to 91.50
MHz FM broadcast.
wo
CREEP
G
iS
Cae
Lp |
(PRES ee 3 eee
2. Press the CHARACTER
key.
3. Press the TUNING
UP key twenty-three time to select
Wy"
__A->B-C-~D-E-F~G?-H-|l>
J > KLM
o> NO
Advertisement
