Panasonic SD-YD250 Manual page 11

Automatic bread maker

Hide thumbs Also See for SD-YD250:

5. Pull out and disconnect the connector on the circuit board.

)

Removal of Positive Lock connector

The positive lock connector is a specialty designed loose connector. / To remove this

connector, pull the lead wire by pressing an extruded lever in the center of receptance terminal.

6. Remove the screw.

7. Remove the PCB holder assembly. (Fig.11)

Parts Name

No.

1 Angle

2 Screw

3 PCB-(B)

4 PCB holder

2.3. Bottom plate, and body Disassembly

Note:

Please detach Control panel and Top lid to the start, and remove the connector connection of

lead wires.

1. Remove the six screws which secure the heater case from the

sides. (Fig.8)

Fig.11

Fig.8

(Fig.11

Table of Contents