DeWalt DCSNP2142 Instruction Manual page 16

TURNING OFF THE SNOW BLOWER
1. Release the auger control bail to stop the motor and auger
(Figure 11).
2. Remove the safety key if snow blower is to be left unattended
ADJUSTING AUGER SPEED/POWER LEVEL
NOTE: The snow blower will start in standard mode.
The mode button is used to cycle through the Three operational
modes of the snow blower (Figure 12).
1. Press the mode button (a) to change from the standard
Mode to the max power mode. Max power mode indicator
(b) lights up.
2. Press the mode button again to change from max power
mode to eco mode. Max power mode indicator goes out and
the eco mode indicator (c) lights up.
3. Press the mode button again to change from eco mode to
standard mode. Both eco and max power mode indicators
will go out.
c
Figure 12
Adjusting the Chute Direction and Pitch
NOTE: The Chute must be rotated to the left or right before
folding the handle.
CHUTE DIRECTION
• Rotating Chute to The Left - Press and hold the left side chute
direction control (b) until the desired position has been
achieved. Release the left side chute direction control.
• Rotating Chute to The Right - Press and hold the right side
chute direction control (a) until the desired position has been
achieved. Release the right side chute direction control.
a
Figure 13
OPERATION
b
a
b
CHUTE PITCH
NOTE: Chute pitch controls the angle and distance of how far
snow is blown.
1. Loosen wing nut (a) (Figure 14).
2. Pivot the upper chute assembly upward or downward to
desired position.
3. Tighten wing nut.
REMOVING THE BATTERY(IES)
IMPORTANT: Recommended use with two DCB612 batteries.
When one or both batteries need to be charged, follow the steps
below to remove them:
1. Lift up the battery housing lid.
2. Push in the battery release tab (a).
3. While pushing in the battery release tab, firmly pull the
battery (b) out from the battery port (c).
NOTE: If necessary, repeat STEPS 2 and 3 to remove the
remaining battery from the snow blower.
NOTE: To replace with charged battery, refer to Installing Battery
on page 11.
4. Close battery housing lid.
5. Repeat STEPS 2 and 3 to remove the second battery.
6. Close battery housing lid.
14
a
Figure 14
a
b
Figure 15
c