Chute Assembly; Installing Battery - DeWalt DCSNP2142 Instruction Manual

Chute Assembly

1. Remove the hex washer screws (a) in the chute base
(Figure 6).
a
a
a
Figure 6
2. Align the holes in the chute base with the three tabs (b) in
the lower chute.
3. Secure the chute base with the hex washer screws (a) removed
in Step 2 (Figure 7).
a
a
b
Figure 7
Set-Up
CHECKING THE BATTERY CHARGE LEVEL
Press the charge meter button on the battery (Figure 8). The
number of lights that illuminate will indicate the current charge
level of the battery. If all three lights are dark, charge the battery
before any further use. Refer to Charging a Battery on page 8.
Low
(Charge Battery)
Charge Meter
Button
Figure 8
ASSEMBLY
a
Full
Charge
Medium Charge
NOTE: While in use, lithium-ion batteries provide power with
minimal power fade. When the battery is fully discharged, it will
immediately cut power to the snow blower and require charging.
Do not expose the snow blower to rain or wet conditions.

INSTALLING BATTERY

IMPORTANT: Only use DeWalt Flexvolt battery system batteries
(DCB612 recommended) with this snow blower.
NOTE: The snow blower can operate with a single, fully charged
battery but it is not recommended as it will result in less run time
and reduced performance.
60 60
=
+
V V
1. Lift up the battery housing lid.
2. Slide one battery (a) into the battery port (b) so that the
battery indicator light faces up from the battery port (Figure
9).
3. Push the battery firmly until the battery locks into place.
There should be an audible "click" when the battery is in
position.
4. Repeat STEPS 2 and 3 to install a second battery into the
remaining battery port.
5. Close battery housing lid and ensure the battery housing lid
snaps into the shroud.
11
WARNING
Ah
a
b
Figure 9