2
Installing the Heater Control
Panel
Parts needed for this procedure:
1
Heater control panel
1
Rotary switch
1
Rotary linear switch
2
Switch nut (7/16 inch)
2
Knob
4
Button-head bolt (5/8 inch)
4
Locknut (#10-24)
1
Control cable
1
Wire harness
Procedure
1.
On the dashboard, remove the 4 switch plugs
and cut out the material between the switch
cutouts
(Figure
3).
Figure 3
2.
Locate the 2 drill pilot dimples
drill 2 pilot holes (3/16 inch) directly over the
pilot dimples.
1. Drill pilot dimples
WARNING
Using a drill without wearing eye
protection may allow debris to enter the
eye, causing personal injury.
When drilling, always wear eye
protection.
3.
Using the heater control panel as a template,
drill the other 2 holes located on the right side.
4.
Install the 2 switches onto the control panel with
2 switch nuts (7/16 inch) as shown in A of
5.
5.
Install a knob over each switch (B of
g398819
4
(Figure
4) and
Figure 4
Figure
Figure 5
g398820
Figure
5).
g430408