Table of Contents
Advertisement
1
Preparing the Machine
No Parts Required
Procedure
1.
Park the machine on a level surface.
2.
Shift the transmission lever to the P (P
position.
3.
Shut off the engine and remove the key.
4.
Wait for the engine to cool completely.
ARK
Figure 1
5.
Disconnect the negative (-) battery cable from
the battery post.
)
1. Negative (-) battery cable
6.
Raise the hood; refer to the machine Operator's
Manual.
7.
Drain approximately 2 L (1/2 US gallon) of
engine coolant (or until coolant stops flowing out
of the rubber hoses) from the cooling system;
refer to the Operator's Manual.
Note:
Retain coolant for reuse after installation
of the kit.
g364252
3
Figure 2
2. Battery post
g365494
Advertisement
Table of Contents
