Lan Connection; Lan For Operation Management (Mnt Port) - Fujitsu ETERNUS DX100 S4 Design Manual

4. Connection Configuration

LAN Connection

LAN Connection
The ETERNUS DX requires a LAN connection for operation management.
In addition, information such as ETERNUS DX failures is notified to the remote support center.
Make sure to connect each controller to the LAN for operation management.
Specifications for the LAN ports of the ETERNUS DX are shown below.
Operation Mode
•
Ethernet (1000BASE-T/100BASE-TX/10BASE-T)
• Internet Protocol
IPv4 and IPv6 are supported.
■
IP Addresses for the ETERNUS DX
In order to connect to the LAN for operation management, an IP address for ETERNUS DX must be
prepared in advance.

LAN for Operation Management (MNT Port)

In an ETERNUS DX, the system administrator logs on to the ETERNUS DX via a LAN to set the RAID
configuration, manage operations, and perform maintenance.
In addition, the failures that occur in the ETERNUS DX are notified to the remote support center.
The remote support uses MNT ports for a network connection by default. In this situation, the net-
work connection for the remote support is transferred via the LAN for operation management.
When the network connection for the remote support needs to be separated from the LAN for op-
eration management, refer to
ports to connect to the remote support center via a different network.
Fujitsu Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Design Guide (Basic)
"LAN for Remote Support (RMT Port)" (page 158)
156
Copyright 2023 Fujitsu Limited
and use the RMT
P3AM-7642-32ENZ0