Table of Contents
Advertisement
StarBoard Link EZ2
2.1 Installing the StarBoard Software
Before Starting to Connect Equipment
Install the StarBoard Software on your PC before starting to connect equipment. The
equipment might not operate correctly if it is connected without the software being
installed.
About PC Earth
Depending on your PC, an incorrect operation might be caused by PC noise via the
USB cable. If this happens, verify that the earth of your PC's power supply cable is
connected.
If the earth is not connected, it might cause an incorrect operation.
2.2 Installing the Devices (Using the Installation Wizard)
- For Windows users, run "Start" → "All
Programs" → "StarBoard Link EZ Setup
Wizard".
For the next steps in the device installation, follow the instructions in the installation wizard.
The StarBoard will be available for use when the wizard procedures are completed.
If you have moved the StarBoard Link EZ2 to a different installation location, run the
"StarBoard Link EZ Setup Wizard" again.
- For Mac users, run "Go" → "Applications"
→"StarBoard Link EZ Setup Wizard".
2-2
Assembly and Setup
English
Advertisement
Table of Contents
