Burner Operation - Whirlpool AKM 293/IX Instructions For Use Manual

DESCRIPTION OF PRODUCT AND SYMBOLS
1. Removable grids
2. 4-crown burner
3. Semi-rapid burner
4. Auxiliary burner
5. 4-crown burner control knob
6. Semi-rapid burner control knob
7. Auxiliary burner control knob
Symbols
Cock closed
Max. flame
Min. flame

BURNER OPERATION

1. Turn the corresponding knob anticlockwise to
the max. flame symbol.
2. Press the knob against the control panel to light
the burner.
3. When the burner is lit, keep the knob pressed
for about 5 seconds to allow the thermocouple
(provided for each burner) to heat up.
This safety device shuts off the gas if the flame
goes out accidentally (draughts, interruption of
gas, liquids boiling over, etc.).
18
2
5
The device must not be operated for more
than 15 sec. If the burner does not remain lit
after this time, wait at least one minute before
trying to light it again.
It may happen that the burner goes out when
the knob is released. This means that the
thermocouple has not heated up enough.
In this case, repeat the operations described
above.
6
3
4
7
1