Starting The Engine - Toro 38751 Operator's Manual

R-c commercial snowthrower
Hide thumbs Also See for 38751:
Table of Contents

Advertisement

Use extension cords and receptacles as specified by
the manufacturer for all machines with electric-starting
motors.
Do not attempt to clear snow from a gravel or crushed
rock surface. This product is intended for use only on
paved surfaces.
Do not use the machine on a roof.
Never attempt to make any adjustments while the engine
is running (except when specifically recommended by
manufacturer).
Stay alert for hidden hazards or traffic.
After striking a foreign object, shut off the engine,
remove the ignition key, thoroughly inspect the machine
for any damage, and repair the damage before starting
and operating the machine.
If the machine should start to vibrate abnormally, shut off
the engine and check immediately for the cause.
Do not run the engine indoors, except when starting
the engine and for transporting the machine in or out
of the building. Open the outside doors; exhaust fumes
are dangerous.
Do not overload the machine capacity by attempting to
clear snow at too fast a rate.
Never touch a hot engine or muffler.
Thoroughly inspect the electrical cord before plugging
it into a power source. If the cord is damaged, do not
use it to start the machine. Replace the damaged cord
immediately. Unplug the power cord whenever you are
not starting the machine.

Starting the Engine

1. Turn the ignition key clockwise to the O
(Figure
12).
2. Pull out the choke lever
position
N
Figure 12
(Figure 13
and
Figure
1. Choke lever
1. Symbols on the choke lever indicating to pull out the choke
lever to activate the choke
3. Firmly push in the primer 3 times with your thumb,
holding the primer in for a second before releasing it
each time
Note: Remove your glove when you push in the
primer so that air cannot escape from the primer hole.
Important: Do not use the primer or the choke if
the engine has been running and is hot. Excessive
priming may flood the engine and prevent it from
starting.
4. Pull the recoil-start handle
14).
8
Figure 13
Figure 14
(Figure
15).
Figure 15
(Figure
16).

Advertisement

Table of Contents
loading

This manual is also suitable for:

Power clear 721

Table of Contents