Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
1
Unfolding the Handle
Parts needed for this procedure:
2
Bolt
2
Nut
Procedure
1. Rotate the handle to the operating position, install 2
nuts and 2 bolts, then tighten the 2 nuts and 2 bolts
already installed holding the handle in place
2. Ensure that you do not pinch or kink the control cable
(Figure
5).
Description
Bolt
Nut
Discharge chute
Chute handle
Phillips-head bolt
Washer
Locknut
(Figure
Figure 4
Qty.
2
Unfold the handle.
2
1
1
Install the discharge chute.
3
3
3
4).
1. Control cable
2
Installing the Discharge Chute
Parts needed for this procedure:
1
Discharge chute
1
Chute handle
3
Phillips-head bolt
3
Washer
3
Locknut
Procedure
Install the discharge chute as shown
4
Use
Figure 5
(Figure
6).