4
Adjusting the Control Cable
No Parts Required
Procedure
Refer to
Adjusting the Control Cable (page
Product Overview
12).
1. Discharge chute
2. Discharge-chute handle
3. Fuel-tank cap
4. Control bar
5. Recoil-start handle
Operation
Before Operation
Safety
•
•
•
•
•
Filling the Fuel Tank
•
6
Figure 9
Use extension cords and receptacles as specified by
the manufacturer for all machines with electric-starting
motors.
Do not operate the machine without wearing adequate
winter garments. Avoid loose fitting clothing that can get
caught in moving parts. Wear slip resistant footwear that
will improve footing on slippery surfaces.
Always eye protection during operation or while
performing an adjustment or repair to protect your eyes
from foreign objects that the machine may throw.
Thoroughly inspect the area where you will use the
machine and remove all doormats, sleds, boards, wires,
and other foreign objects.
If a shield, safety device, or decal is damaged, illegible, or
lost, repair or replace it before beginning operation. Also,
tighten any loose fasteners.
For best results, use only clean, fresh, unleaded gasoline
with an octane rating of 87 or higher ((R+M)/2 rating
method).
6. Primer
7. Ignition key
8. Choke lever
9. Oil-drain plug
10. Oil-fill cap