Pf Recognition - Canon Die Bonder BESTEM-D01 Manual

BESTEM – D01R

4. Pf Recognition

When Pf recognition button in recognition main screen is clicked, the below screen will be displayed and Pf
recognition teaching can be done. 「Pf Base」 , 「Template」 , 「NG Mark」 setting and the procedures for Pf recognition
are same as Island recognition (will not explain here). Below will only explain for 「1st Chip」detection.
【1st Chip detection】
If 「1st Chip」 tab is clicked, the above screen will be displayed. This is the mode to check the existing of chips after
first or second time mounting process. The maximum chip that is allow to be confirm is 4 chips.
※But, When AgP paste and chip are of the same color, It cannot differentiate between chip and AgP paste.
１． "1st chip existence detect parameter setting"
①
"1st chip existence detect" --- Set 1st chip detection "ON/OFF".
②
"1st chip existence detect execution sequence" --- Select the sequence for first chip existence detection.
③
"1st chip detect position XY/size WH [pixel]" --- Set the checking window for the target chip.
④
"3 level setting" --- Please set the thresh level for the target check chip. When clicking or scrolling the
scroll bar, detection region on the picture image will turn green. Set so that the 1
colour.
⑤
"Y Offset Setting (Standard = 0)" --- The setting that use if first chip is outside the image view.
(Please refer to next page for figure illustration).
All manuals and user guides at all-guides.com
st
chip turn to green
P．18