Table of Contents
Advertisement
Question: Why doesn't the DVD movie play smoothly?
•
Ensure to use AC power.
•
Set back the screen resolution, color quality, and screen refresh rate to the default
value of 1024x768, 16bit, and 60Hz.
Question: Why isn't the optical drive recognized?
•
If the computer is turned on with some kind of DVD disks inserted in the drive,
the drive may not be recognized. In this case, turn off the computer and open the
disk tray by the way on Question: Why does not the drive open? on the previous
page. Remove the disk from the drive; then turn on the computer again.
•
You might remove the optical drive MATSHITA UJDA730 DVD/CD-RW Drive
(E:) in Windows by clicking (
below.
1. Close Recording Control dialog box.
2. Turn off the computer and remove the optical drive by following the steps
described Installing the Weight Saver section in Appendixes.
3. Reinstall the optical drive slightly.
4. Turn on the computer.
Trouble with Communication
Question: Why can't I communicate through the built-in modem?
•
Confirm the telephone line is properly connected to the modem jack.
•
Confirm the dial setting (pulse or tone) of Windows XP and/or communication
software are matched with the telephone line.
•
If you set your connection status using New Connection Wizard, check Use
dialing rules in the Properties dialog box of that connection status. Refer to
Internet Connection of Chapter 5.
•
Confirm the country/region setting is appropriate.
•
Confirm the network configuration is appropriate.
•
Confirm the user name or password is correct.
•
Confirm the COM port in the communication software is set appropriately.
•
Turn off the power management in the Windows.
•
If an unusual device is attached to the line you are connecting to, the modem may
not function properly. Remove the device or contact the dealer of the device.
T-6
) or ( ) icon on the taskbar. Follow the steps
Advertisement
Table of Contents
