Canon Pixma MP495 Series On-Screen Manual page 744

Cannot Print or Scan from a Computer Connected to the Network
>
Advanced Guide About Network Communication
to the Network
N045
Cannot Print or Scan from a Computer Connected to the
Network
Check 1: Make sure that the network settings of the computer are
correct.
For the procedures to set up the computer, refer to the manual of your computer or contact its
manufacturer.
Check 2: If the MP Drivers is not installed, install the MP Drivers.
Insert the Setup CD-ROM into the computer's disc drive and perform Custom Install and select MP
Drivers to install again.
Check 3: Make sure that access control is not set to the access point.
For the procedures to connect an access point and set it up, refer to the manual of your access point
or contact its manufacturer.
Note
To check the MAC address or the IP address of the computer, see
the MAC Address of the Computer
> > Cannot Print or Scan from a Computer Connected
Troubleshooting
.
Page 744 of 759 pages
Checking the IP Address or
Page top