Table of Contents
Advertisement
Enhancement Parameters
This section identifies all SITRANS LU10 operator programmable features designed for
altering operation to suit individual operator preferences or overcome measurement
difficulties.
Typically, these parameters are only altered as directed by the Troubleshooting Guide . If
RUN mode performance requires improvement, access and alter the following
parameters as required. Otherwise, proceed to Operation.
Parameter Category
Data Logging
Profile Records
Installation Records
Range Calibration
Temperature Compensation
Rate
Measurement Verification
Scanning
Display Parameters
SmartLinx Parameters
Echo Processing
Advanced Echo Processing
Test Parameters
Measurement Parameters
Master Reset
When an Enhancement Parameter is altered, return to the RUN mode to verify the
When an Enhancement Parameter is altered, return to the RUN mode to verify the
When an Enhancement Parameter is altered, return to the RUN mode to verify the
When an Enhancement Parameter is altered, return to the RUN mode to verify the
performance desired is achieved before making any other changes.
performance desired is achieved before making any other changes.
performance desired is achieved before making any other changes.
performance desired is achieved before making any other changes.
Data Logging Parameters (P300 and P302)
View the maximum temperature recorded in the RUN mode.
P300 (V) TEMPERATURE, TRANSDUCER MAX
Use this feature if vessel temperature is monitored by an Ultrasonic /
Temperature transducer to view the highest temperature recorded (in °C).
values: -50 to 150
7ML19985AN02
to view previous maximum Temperature records
intended for use by Siemens Milltronics Service personnel
to identify length of service and power failure occurrence
to compensate for measurement offset and/or sound velocity
to override automatic temperature compensation features
to override Measurement Response (P003)
to override Measurement Response (P003)
to override automatic scanning delay or use Aux. Transducer
to override the preset display operating characteristics
communications
to troubleshoot false echo detection
intended for use by Siemens Milltronics Service personnel
intended for use by Siemens Milltronics Service personnel
to verify Application Parameter programming
to reset numerous Parameter Values
SITRANS LU10 – INSTRUCTION MANUAL
Purpose
Page
50
51
54
55
57
59
61
63
65
67
68
70
78
80
81
Page 43
Advertisement
Table of Contents
