Polaris RZR XP 4 1000 EPS 2020 Owner's Manual page 75

5. Turn the ignition key past the ON/RUN position to START. Engage the starter
for a maximum of five seconds. Release the key when the engine starts.
6. If the engine does not start within five seconds, return the ignition switch to
the OFF position and wait five seconds. Repeat steps 5 and 6 until the
engine starts.
7. After starting the engine, wait 10 seconds before applying throttle.
STOPPING THE ENGINE
A rolling vehicle can cause serious injury. Always place the transmission in
PARK and engage the park brake (if equipped) when stopping the engine.
1. Release the throttle pedal completely and brake to a complete stop.
2. Place the transmission in PARK.
3. Turn the engine off.
4. Slowly release the brake pedal and make sure the transmission is in PARK
before exiting the vehicle.
5. Engage the park brake (if equipped).
BRAKING
1. Release the throttle pedal completely.
When the throttle pedal is released completely and engine speed slows to near
2. Press on the brake pedal evenly and firmly.
3. Practice starting and stopping (using the brakes) until you're familiar with the
controls.
PARKING THE VEHICLE
1. Stop the vehicle on a level surface. When parking inside a garage or other
structure, be sure that the structure is well ventilated and that the vehicle is
not close to any source of flame or sparks, including any appliance with pilot
lights.
2. Place the transmission in PARK.
3. Stop the engine.
WARNING
idle, the vehicle has no engine braking.
TIP
OPERATION
73