Table of Contents
Advertisement
3.3 Data Management
Parameter & Description
Firmware Status
Indicates the current firmware status of page 0 and
page 1. There are three kinds of status indication:
•
Main Operation Mode: Active firmware data on
startup under normal operation.
•
OLD: Firmware data uploaded to the card before
the firmware data in the "Main Operation Mode"
status was uploaded.
•
NEW: Firmware data uploaded to the card after
the firmware data in the "Main Operation Mode"
status was uploaded.
Note
The status indications "OLD" and "NEW" are
irrelevant to the version of the firmware data.
Startup Page
Indicates the active page on startup. Generally, the
startup page is the firmware data whose status is
"Main Operation Mode".
The exception is when the card undergoes a reboot
after a firmware data upload operation; in this case, the
card starts up with the page in the "NEW" status. This
is for the purposes of confirming the result of the
upload operation. If you reboot again, the card starts
up with the page in the "Main Operation Mode" status.
To set the updated page as the active page on startup,
you must change its firmware status to "Main
Operation Mode".
Operation
Specifies whether to set the page (selected with the
parameter Select Page) as the active page on startup
("Main Operation Mode"), or delete the page
("Empty").
"Empty" is an option provided for engineer use only.
Select Page
Specifies the target page of the operation selected with
the parameter Operation.
62
Programming Guide
Default
Value Range
Display only
Display only
Not applicable
Empty,
Main Operation Mode
Not applicable
Page-0,
Page-1
Advertisement
Table of Contents
