Table of Contents
Advertisement
5.
Click OK.
You will see a confirmation screen.
Note
If your entry contains an invalid value, you will see an error screen. Click OK and try
again with correct values.
6.
Confirm your entry and click OK.
To return to the previous screen, click CANCEL.
Parameter Descriptions
The parameters indicated with "*" must be changed while the VoIP Gateway Card is in the "STOP"
status (see "2.3.1 Status Control"). The changes do not have to be followed by a reboot to become
effective.
DN2IP Entry
The parameters below are used to create DN2IP entries based on the gateway entries created
previously (see "2.2.6 Address Translation Table—GW Entry"). The DN2IP entries associate dialled
numbers and IP address of the destination; therefore, a caller can reach the destination by dialling the
number without knowing the destination IP address.
For a programming example, refer to "4.2.5 Programming the Address Translation Table" of the VoIP
Gateway Card Getting Started.
Note
If you are using a gatekeeper, create the DN2IP entries only for the local card. In this case, you
can create up to four DN2IP entries per card.
Note that if you are not using a gatekeeper, there is no maximum number of DN2IP entries.
Parameter & Description
*
Leading Number
Specifies the leading digits in dialled numbers by which
to associate calls with the appropriate destination.
For example, to associate calls with dialled numbers
"950-xxxx" and "951-xxxx" with separate destinations,
it is necessary to make two DN2IP entries with
respective numbers, "950" and "951".
*
Remaining Number of Digits
Specifies the number of digits to be dialled following
the leading number to access the destination.
For example, if the dialled numbers are either "950-
xxxx" or "951-xxxx" and the numbers "950" and "951"
are specified for the parameter Leading Number
respectively, specify the number "4" in this parameter.
*
GW No/Group No. Selection
Specifies the type of destination when making calls: a
gateway or a gateway group.
Default
Value Range
No default
Max. 30 digits
0
0 to 29
GW
GW,
Group
2.2 Programming
Programming Guide
35
Advertisement
Table of Contents
