Electrical Connection - Blomberg DW 55502 FBI Installation Manual

tubing or metal braided dishwasher supply line.
• Temperatures required for soldering and sweating will damage the dishwasher's water
inlet valve so if any such operation is needed, keep the heat source min. 7 7 / 8 " (200mm)
away from the dishwasher's water inlet valve.
• There should not be any sharp bends in the water line that may restrict the water flow.
• Teflon tape or pipe tread compound must be used for sealing the connection. Before
connecting the copper water supply line to the dishwasher, flush it with hot water to clear
any foreign material.
Notice :
After connections are made turn on the water supply to check for leaks.

7.2 ELECTRICAL CONNECTION

WARNING
• Make sure the voltage and frequency listed on the data plate correspond with
the household electrical supply. This data must correspond to prevent injury and
machine damage. Consult a qualified electrician if in doubt.
• Only connect the dishwasher to the mains when all installation and plumbing work
is complete.
• Do not use any extension cord or portable outlet device to connect the dishwasher
to a power supply.
• The power-supply receptacle for the appliance shall be installed in a cabinet or on
a wall adjacent to the undercounter space in which the appliance is to be installed.
• The access hole of the supply cord to the installation compartment must be
smooth and rounded and it must be large enough for the attachment plug to pass
through. The longest dimension of the opening shall not be more than 1,5" (38
mm).If the partition is metal, it needs to be covered with the edge protector (m).
• Care must be taken when the appliance is installed or removed, to reduce the
likelihood of damage to the power-supply cord.
7.2.1 GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of a malfunction or breakdown, grounding
will reduce the risk of electric shock by providing a path of least resistance for electric
current. This appliance is equipped with a cord having an equipment-grounding conductor
and a grounding plug. The plug must be plugged into an appropriate outlet that is installed
and grounded in accordance with all local codes and ordinances. This appliance must be
connected to a grounded metal, permanent wiring system, or an equipment-grounding
conductor must be run with the circuit conductors and connected to the equipment-
grounding terminal or lead on the appliance.
WARNING
• Improper connection of the equipment-grounding conductor can result in a risk of
electric shock. Check with a qualified electrician or service representative if you
are in doubt whether the appliance is properly grounded. Do not modify the plug
provided with the appliance, if it will not fit the outlet, have a proper outlet installed
by a qualified electrician.
7.1.2 WATER SUPPLY CONNECTION
Water supply may be connected to the dishwasher in
one of two ways:
• With metal braided hose.
• With copper tubing.
7.1.3 BRAIDED HOSE/COPPER TUBING
After connections are made turn on the water supply to
check for leaks.
CAUTION
• Hot water supply line: Use minimum 3/8" O.D. copper
13
USA