Table of Contents
Advertisement
2.
Look at the outline of the fluid level at the side of
the reservoir
(Figure
Note:
The level should be above the Minimum
line.
Figure 42
1. Brake-fluid reservoir
3.
If the fluid level is low, preform the following:
A.
Clean the area around the reservoir cap
and remove the cap
B.
Add DOT 3 brake fluid to the reservoir until
the fluid level is above the Minimum line
(Figure
42).
Note:
Do not overfill the reservoir with
brake fluid.
C.
Install the reservoir cap
4.
Close the hood.
Replacing the Service and
Parking-Brake Pads
Service Interval: Every 400 hours
Contact your authorized Toro distributor to inspect and
possibly replace the service-brake pads.
Changing the Brake Fluid
Service Interval: Every 1,000 hours/Every 5 years
(whichever comes first)—Change
the brake fluid.
Contact your authorized Toro distributor.
42).
2. Minimum line
(Figure
41).
(Figure
41).
Cleaning
Washing the Machine
Service Interval: Before each use or daily—Wash
Wash the machine as needed using water alone
or with a mild detergent. You may use a rag when
washing the machine.
Important:
Do not use brackish or reclaimed
water to clean the machine.
Important:
Pressurized water is not
recommended when washing the machine. It may
g002136
damage the electrical system, loosen important
decals, or wash away necessary grease at friction
points. Avoid excessive use of water, especially
near the control panel, motor, motor controller,
charger, back of the dashboard, and batteries.
38
the machine.
Advertisement
Table of Contents
