Download Print this page
Sealey PI300.V4 Instructions

Sealey PI300.V4 Instructions

Advertisement

Quick Links

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions and maintained properly, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Warning:
Refer to Instruction
Electricity
Manual
1. SAFETY
 DANGER! - Beware, lead-acid batteries generate explosive gases during normal battery operation.
 Wash immediately with soap and water if battery acid contacts skin or clothing. If acid enters eye, flush immediately with cool clean running
water for at least 15 minutes and seek immediate medical attention.
 DO NOT smoke or allow a spark or flame in the vicinity of the battery or engine.
 If the battery terminals are corroded or dirty, clean them before attaching the clips.
 WARNING! To prevent the risk of sparking, short circuit and possible explosion DO NOT drop metal tools in the battery area, or allow them to
touch the battery terminals.
 Before attaching to battery, remove personal metallic items such as rings, bracelets, necklaces and watches. A lead acid battery can produce a
short-circuit current which is high enough to weld such items to the vehicle and cause severe burns.
 Keep children and unauthorised persons away from the working area.
 WARNING! DO NOT use on any vehicles other than those with 12Vdc systems.
 WARNING! For delicate items such as laptops, an anti-surge device is recommended.
 DO NOT connect to any AC power source.
 DO NOT dismantle. The inverter must be checked by qualified service personnel only.
 DO NOT get inverter wet or use in damp or wet locations or areas where there is condensation.
 DO NOT use the inverter for any purpose other than for which it is designed.
 DO NOT pull the cables or clips from the battery terminals.
 DO NOT operate the inverter if damaged.
 DO NOT connect to a positive earthed system. Ensure you have the polarity correct before connecting, red clip to positive (+) battery terminal
and black clip to negative (-) battery terminal.
 Before connecting ensure nothing is plugged into the inverter, and the inverter is switched OFF.
 WARNING! Inverters become hot during use.
 When not in use store inverter in a safe, dry, childproof location.
2. INTRODUCTION
Supplies continuous smooth 230V power from 12Vdc power supply found in cars, caravans, boats and commercials. Suitable for powering small
TVs, laptops, power tools and various other electrical equipment within the wattage rating of the inverter. Features USB port (5V/2.1A) for use on
various domestic electronic equipment such as digital cameras and mobile phones. Aluminium case provides durability and maximum heat
dissipation. Safety features include automatic overload shut-down, short circuit protection, low voltage alarm, low voltage shutdown and overheat
shutdown. Supplied with vehicle accessory socket plug and/or battery clips depending on model.
3. SPECIFICATION
Model No: . . . . . . . . . . . . . . . . . . . . . . PI300.V . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . PI500.V4
Input Voltage:. . . . . . . . . . . . . . . . . . . . 12Vdc . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12Vdc
Output Voltage/Frequency. . . . . . . . . . 230Vac/50Hz. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .230Vac/50Hz
Continuous Output: . . . . . . . . . . . . . . . 300W. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .500W
Maximum Output: . . . . . . . . . . . . . . . . 600W. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1000W
Dimensions (W x D x H) . . . . . . . . . . . 180 x 105 x 60mm . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 230 x 95 x 58mm
Supply Connection: . . . . . . . . . . . . . . . Vehicle Accessory Plug and Battery Clips . . . . . . . . . . Vehicle Accessory Plug and Battery Clips
USB: . . . . . . . . . . . . . . . . . . . . . . . . . . 5V 2.1A . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5V 2.1A
4. OPERATION
fig.1
© Jack Sealey Limited
INSTRUCTIONS FOR:
POWER INVERTERS 300W, 500W
12V DC - 230V 50HZ
MODEL NO's:
Keep away from
rain
fig.2
PI300.V4
PI300.V4, PI500.V4
PI500.V4
Original Language Version
fig.3
PI300.V4, PI500.V4
Issue: 1 - 15/02/17

Advertisement

loading

Summary of Contents for Sealey PI300.V4

  • Page 1 PI300.V4, PI500.V4 MODEL NO’s: Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions and maintained properly, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
  • Page 2 High Temperature - When the temperature of the internal heat sink reaches 65°C, the solid state temperature sensor will automatically shut down the unit. Once it is allowed to cool, the unit may be restarted. PI300.V4, PI500.V4 Issue: 1 - 15/02/17 Original Language Version © Jack Sealey Limited...
  • Page 3: Maintenance

    Parts support is available for this product. To obtain a parts listing and/or diagram, please log on to www.sealey.co.uk, email sales@sealey.co.uk or telephone 01284 757500. Environmental Protection Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
  • Page 4 … 89/686/EEC PPE Directive … 2014/29/EU Simple Pressure Vessels Directive … 2014/53/EU RTTE Directive Manufacturer’s authorised representative within the EC: Jack Sealey Ltd, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR Conforms to the requirements of the Directives, as indicated�...
  • Page 5 … 89/686/EEC PPE Directive … 2014/29/EU Simple Pressure Vessels Directive … 2014/53/EU RTTE Directive Manufacturer’s authorised representative within the EC: Jack Sealey Ltd, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR Conforms to the requirements of the Directives, as indicated�...

This manual is also suitable for:

Pi500.v4Pi300.v