Zanussi ZPAC9002 Manual page 10

INSTALLING YOUR AIR
2. Assembly
•
Slide Panel B into Panel A and size to the width of the window
(window size may vary). When sizing the window width, be sure
that the window assembly kit is free from any gaps and/or air
pockets when taking measurements.
•
Place the locking pin into the corresponding hole. Ensuring the
installation kit is the correct size, without gaps or air pockets
Location
•
The unit should be placed on firm ground to help minimise noise
and vibration. For safe and secure positioning, place the unit on a
smooth, level floor which is strong enough to support the unit.
•
This unit has castors to aid placement but it should only be rolled
on smooth, flat surfaces. Use caution when rolling on carpeted and
wooden surfaces. Do not attempt to roll the unit over other
objects.
•
The unit must be placed within reach of a properly rated grounded
socket.
•
Never place any obstacles around the air inlet or outlet of the unit.
•
Allow at least 45cm of space around, above and away from the
wall to ensure the appliance works efficiently.
•
The hose can be extended but it is best to keep it to the minimum
length required. Also ensure that the hose does not have any sharp
bends or sags.
CONDITIONER
Page 10
.