Table of Contents
Advertisement
3
Installation
Before the calling the nearest Authorised
Service for the installation of the dryer, en-
sure that electrical installation and water
drain is appropriate referring to the user's
manual.(See 3.3 Connecting to the drain
and 3.5 Electrical connection) If they are
not suitable, contact a qualified electrician
and technician to make necessary arrange-
ments.
C
Preparation of the dryer's location
as well as the electrical and
waste water installations is under
customer's responsibility.
A
Prior to installation, visually check
if the dryer has any defects on
it. If the drier is damaged, do
not have it installed. Damaged
products cause risks for your
safety.
3.1 Appropriate installation
location
Install the dryer on a stable and level
surface.
Dryer is heavy. Do not move it by yourself.
•
Operate your dryer in a well ventilated,
dust-free environment.
•
The gap between the dryer and the
surface should not be reduced by the
materials such as carpet, wood and
tape.
•
Do not cover the ventilation grills of the
dryer.
•
There must not be a lockable, sliding or
hinged door that may block the opening
of the loading door in the place where
your dryer is to be installed.
•
Once the dryer is installed, it should stay
at the same place where its connections
have been made. When installing the
dryer, make sure that its rear wall does
not touch anywhere (tap, socket, etc.).
•
Place the dryer at least 1 cm away from
the edges of other furniture.
•
Your dryer can be operated at
temperatures between +5°C and +35°C.
If the operating conditions fall outside
of this range, operation of the dryer will
be adversely affected and it can get
damaged.
Dryer / User Manual
•
The rear surface of the tumble dryer
shall be placed against a wall.
B
Do not place the dryer
power cable.
3.2 Removing the
transportation safety assembly
A
Remove the transportation safety
assembly before using the dryer
for the first time.
Open the loading door.
There is a nylon bag inside the drum that
contains a piece of styrofoam. Hold it from its
section marked with XX XX.
Pull the nylon towards yourself and remove
the transportation safety assembly.
A
Check that no part of the
transportation safety assembly
remains inside the drum.
3.3 Connecting to the drain
In products equipped with condenser unit,
water accumulates in the water tank during
the drying cycle. You should drain accumu-
lated water after each drying cycle.
You can directly drain accumulated water
through the water drain hose supplied with
the product instead of periodically draining
the water collected in the water tank.
Connecting the water drain hose
1-2 Pull hose at the behind of the dryer by
hand in order to disconnect it from where it is
connected. Do not use any tools to remove
the hose.
3 Connect one end of the drain hose sup-
plied with the dryer to the connection point
from where you removed the hose of the
product in previous step.
4 Connect the other end of the drain hose
directly to the wastewater drain or to the
washbasin.
on the
15 / EN
Advertisement
Table of Contents
