Servicing The Air Cleaner - Toro 22305A Operator's Manual

1. Lower the loader arms and stop the engine.
Remove the key.
2. Clean the grease fittings with a rag.
3. Connect a grease gun to each fitting
(Fig 17 and 18).
Figure 17
Figure 18
4. Pump grease into the fittings until grease begins
to ooze out of the bearings (approximately 3
pumps).
5. Wipe up any excess grease.

Servicing the Air Cleaner

Clean the primary filter every 25 operating hours.
Replace the primary and secondary filter yearly.
Note:
Removing the Filter
1. Lower the loader arms and stop the engine.
Remove the key.
2. Release the latches on the air cleaner and pull the
air cleaner cover off of the air cleaner body
(Fig. 19).
3. Clean the inside of the air cleaner cover with
compressed air.
4. Gently slide the primary filter out of the air
cleaner body (Fig. 19). Avoid knocking the
filter into the side of the body. Do not remove
the safety filter, unless you intend to replace it as
m–4396
well.
5. Inspect the primary filter for damage by looking
into the filter while shining a bright light on the
outside of the filter. Holes in the filter will
appear as bright spots. If the filter is damaged,
discard it, otherwise clean it.
IMPORTANT: Never attempt to clean the
safety filter. If the safety filter is dirty, then
m–4056
the primary filter is damaged and you should
replace both filters.
Service the air cleaner more frequently
if operating conditions are extremely
dusty or sandy.
Maintenance
27