Table of Contents
Advertisement
Fault
Rust spots on cutlery.
Detergent residue is
present in the deter-
gent dispenser or the
tablet collecting tray.
Excessive formation of
foam occurs.
Connection to home
network is not estab-
lished.
WLAN display is flash-
ing.
Home Connect cannot
be implemented cor-
rectly.
Special salt refill indic-
ator lights up.
Cause and troubleshooting
Do not wash rusting items.
▶
Salt content in washing water is too high.
Remove any spilled special salt from the tub.
1.
Screw the cap of the special salt dispenser on tight.
2.
Spray arms were blocked by tableware so detergent
was not rinsed out.
Check that the spray arms are not blocked and can
▶
rotate freely.
Detergent dispenser was damp when detergent was
added.
Only add detergent to a detergent dispenser when
▶
dry.
Hand washing-up liquid is present in dispenser for
rinse aid.
Immediately add rinse aid to the dispenser.
▶
→ "Adding rinse aid", Page 33
Rinse aid has been spilled.
Remove the rinse aid with a cloth.
▶
Detergent or appliance care product used causes ex-
cessive foaming.
Change the brand of detergent.
▶
WLAN on router is not active.
Check the wireless network connection of your
▶
router.
Connection to home network is not available.
Activate the wireless network connection on your
▶
router.
Home Connect set incorrectly.
Please consult the documents supplied for
▶
Home Connect.
Technical fault is present.
Please consult the information about support in the
▶
documents supplied for Home Connect.
Insufficient special salt.
Add Special salt → Page 31.
▶
Sensor does not detect special salt tablets.
Do not use special salt tablets.
▶
Troubleshooting en
61
Advertisement
Table of Contents
