Advertisement
4. OPERATION
Torque
Selector Ring
10mm Keyless Chuck
LED Worklight
Speed Control
Trigger
Battery Latch
fig.1
IMPORTANT WARRANTY INFORMATION:
The battery pack fitted to this cordless tool is considered to be a consumable item and its ability to accept charge will reduce over
time. We will warranty it against mechanical and electrical defect for a period of one year - this does not cover fair wear and tear. If
the battery is not properly charged before first use, or regularly conditioned, its capacity will diminish. Under these circumstances we
will not replace the battery pack even if it is less than one year old.
4.1.
BATTERY CHARGING
4.1.1.
Plug the charger into a mains electric socket. When switched on, the charger LED will display a green aspect.
4.1.2.
To release the battery press the battery latch and slide the battery forward.
4.1.3.
Slide the battery into the charger (fig.2). The charger LED will display a steady red aspect to show that charging is taking place.
4.1.4.
When the battery is fully charged, a green aspect will return. Allow the battery to cool before use.
4.1.5.
Replace the battery in the drill, sliding in until secured by the latch.
NOTE: When new, the battery may have been shipped in a low charge state. It will take longer to charge the battery initially and several
subsequent charges may also take a little longer, compared with when the battery reaches its optimum performance.
4.2.
USING THE DRILL (fig.1)
4.2.1.
Ensure that you have read, understood and comply with all the safety instructions in Section 1
4.2.2.
Ensure the direction switch is in the mid (lock) position. Open the chuck and insert the required drill or screwdriver bit.
4.2.3.
Select high or low speed by using the selector on top of the casing (high speed for drilling, low for hammer or driving screws).
4.2.4.
Select the direction of rotation by means of the forward/reverse selector.
4.2.5.
Select hammer, screw or drill by turning the selector ring.
4.2.6.
If driving screws, set the required torque by means of the torque selector ring. 1 is the lowest torque setting.
4.2.7.
The LED work-light is lit whenever the trigger is depressed.
4.2.8.
When the trigger is depressed, the charge level display is also illuminated. When green, amber and red lights are showing, the charge
level is healthy. As the charge level drops, the indicator lights go out progressively. When just the red light is showing, the battery
requires recharging.
4.2.9.
When finished, remove the bit, clean the drill and bit and replace the drill in its case.
4.2.10.
Store in a cool, dry place out of the reach of children.
© Jack Sealey Limited
Hammer / Screw / Drill Selector
Ring
High / Low Speed Selector
Original Language Version
Charge Level
Display
Forward / Reverse
Red LED
Selector
Charging
Green LED
Power
fig.2
Belt Clip
CP18VLD.V2 Issue 1 07/11/22
Advertisement
