Tips And Tricks; Repairs; Trouble Shooting - SIP 01332 Manual

11. Tips and Tricks

Before cutting a work-piece to size make trial cuts with
pieces of scrap.
Always place a work-piece on the saw table in such way
that it can not tilt or rock (e.g. always place a curved
board on the table with the convex side up).
When working long stock use suitable supports, such
as table rear or side extensions (optional accessories).
Keep surfaces of saw table and saw base clean - in
particular, remove resin residue with a suitable
cleaning and maintenance spray.
Problem
Motor is slow or weak
Motor overheats.
When ripping, the cut burns the
work-piece, or stalls the motor.
Miter-gauge does not move
freely.
Rip Fence does not move
smoothly.
Bevel & Height Handles are
hard to turn.
10" saw blade does not lower
when turning the
Handle.
Table saw vibrates excessively.
Trouble Shooting Guide, (cont.)
Cause
Voltage from source is low.
Windings are burned out or open.
Power Switch is defective.
Circuit is overloaded with appliances,
lights, or other electrically powered
equipment.
Motor is overloaded.
Dull 10" saw blade.
Sawdust inside table saw is blocking
airflow.
10" saw blade teeth are dull.
Work-piece is warped.
Rip fence is not parallel with the 10" saw
blade.
Miter gauge assembly is dirty.
Rip Fence is mounted incorrectly.
Sawdust has
mechanisms inside the base.
Bevel Lock Handle is not fully released.
Height
Floor surface is uneven.
V-belt is damaged.
10" saw blade is damaged.
Loose bolt, Screws, Nuts.

12. Repairs

Danger!
Repairs to electric tools must be carried out by
qualified electricians only!
Electric tools in need of repair can be sent to the service
centre of your country.
Refer to the spare parts list for the address.
Please attach a description of the fault to the electric tool.

13. Trouble Shooting

Danger!
Before carrying out any fault service or maintenance
work always:
1. switch machine OFF
2. unplug power cable
3. wait for saw table to come to standstill.
Request a voltage check from local
power company.
Have the Motor checked / repaired.
Have the Power Switch replaced.
Do not use other appliances or
electrically powered equipment on the
same circuit when using the Table Saw.
Request a voltage check from the local
power company.
Replace the 10" saw blade.
Clean out the saw base.
Sharpen or replace the 10" saw blade.
Replace the work-piece.
Realign rip fence, and lock it in position
with the Rip Fence Handle.
Loosen the miter gauge knob, clean and
lubricate the Miter Gauge Rod.
Remove, reposition Rip Fence, and lock
it in position with the Rip Fence Handle.
collected on the Clean and lubricate the mechanisms
inside the base.
Fully release the Bevel Lock Handle.
Readjust the Leveling Feet.
Replace the V-belt.
Replace the 10" Saw Blade.
Tighten all Hardware.
1 2
Solution