Care And Maintenance; Saw Blade Change - SIP 01332 Manual

10. Care and maintenance

Danger!
Prior to all servicing:
- Switch machine OFF.
- Unplug power cable.
- Wait until the saw has come to a complete stop.
Check that all safety devices are operational against
after each service.
Replace defective parts, especially of safety devices,
only with genuine replacement parts. Parts not tested
and approved by the equipment maker can cause
unforeseen damage.
Repair and maintenance work other than described in
this section shall be only carried out by qualified
specialists.

10.1 Saw blade change

Danger!
Risk of injury by the saw blade's teeth. Wear gloves
when changing blades.
1. Remove blade guard.
2. Lower saw blade fully.
3. Loosen 6 screws on cover plates. Remove throat
plates slightly.
4. Raise saw blade fully.
5. To block the saw blade insert lock bar into hole in
the saw table and turn saw blade by hand until lock
bar engages in saw spindle hole.
6. Loosen saw blade spindle arbor nut with spanner
(L.H. thread!)
7. Take outer blade collar and saw blade off the saw
spindle.
8. Clean clamping surfaces of saw spindle and saw
blade.
Danger!
Do not use cleaning agents (e.g. for removing
resin residue) that could corrode the light metal
components the saw, the stability of the saw
would be adversely affected.
9. Put on a fresh saw blade.
Danger!
Use only suitable saw blades - when using unsuitable
damaged blades parts could be explosive like hurled
from it by the centrifugal force.
Do not use:
- saw blades with visible damage;
- cut-off wheel blades.
10. Slide outer blade collar onto saw spindle.
11. Screw arbor nut, with the low side facing the blade,
onto the saw spindle (L.H. thread)
10