Intended Use - DeWalt XR DCMW564N Original Instructions Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 34
EnGLIsH
Upper handle knobs
10
Battery port cover
11
Cut height adjust lever
12
Rear door cover
13
Grass collection bag
14
Grass collection bag handle
15
Upper carrying handle
16
Lower carrying handle
17

Intended Use

This lawn mower has been designed for professional lawn
mowing applications.
DO nOT use under wet conditions or in presence of flammable
liquids or gases.
This lawn mower is a professional lawn care appliance.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
ASSEMBLY

DANGER: To reduce the risk of serious personal
injury, turn unit off, remove safety key, and remove
battery packs before assembly, making any
adjustments or removing/installing attachments or
accessories. An accidental start-up can cause injury.
Attaching Upper Handle (Fig. A, C)
1. Line up the holes on the bottom of the upper
handle 
with the holes on the top of the lower handle 
 6
nOTE: Make sure the cord is located on the front of both
handles. If it is not it may result in the cord tangling and the
inability to easily store the mower.
2. From the inside of the upper handle 
through the holes.
3. Loosely tighten the knob to the bolt.
4. Rotate the upper handle 
5. Tighten the upper handle knobs 
secured into position.
Adjusting Handle Height (Fig. D)
The mower is shipped in storage mode. You will need to adjust
the handle to operating position before continuing.
1. To unlock the lower handle 
quarter turn the two lower handle locks 
sides of the lower handle as shown in Fig. D.
2. Raise the lower handle to operating position.
3. Locate the two handle height adjustment detent holes 
located on the lower handle brackets 
4. Adjust the lower handle to the position that best fits the
operator and lock the lower handle in place by twisting
the lower handle locks 
desired detent holes.
40
 6
, slide the knob bolt
 6
into its operating position.
so the upper handle is
 10 
from storage position, twist a
 5 
located on both
 7 
 8 
as shown in Fig. D.
 7 
allowing them to snap into the
Grass Collection Bag (Fig. E, F)

DANGER: Remove safety key and battery packs before
removing mulching insert, and when opening rear door
cover and installing bag.
1. Ensure the mulching insert 
mower before proceeding to step 2.
2. Lift the rear door cover 
bag 
 14 
onto the mower so the bag hooks 
lugs 
 21 
as shown in Fig. E. Then lower the rear door cover.
Grass Mulching Insert (Fig. A, F)

DANGER: Remove safety key and battery packs
before removing collection bag, and when installing
mulching insert.
1. Ensure the grass collection bag 
before proceeding to step 2.
2. Lift the rear door cover 
insert 
 18 
fully into the mower as shown in Fig. F.
3. Ensure the rear door cover is down before turning mower on.
Rear Discharge

DANGER: Remove safety key and battery packs before
removing collection bag, and mulching insert.
1. To operate mower in rear discharge mode remove both the
bag and the mulching insert.
2. Be sure rear door cover is down for rear discharge.
nOTE: The rear door is shaped in such a way that the opening
(at the bottom) cannot be completely closed off.
.
 5 
OPERATION

DANGER: To reduce the risk of serious personal
injury, turn unit off, remove safety key, and remove
battery packs before making any adjustments or
removing/installing attachments or accessories. An
accidental start-up can cause injury.
Installing and Removing the Battery Packs
(Fig. G)

DANGER: MAKE CERTAIN THE SAFETY KEY IS
REMOVED TO PREVENT ACTUATION BEFORE
REMOVING OR INSTALLING BATTERY.
This mower is designed to operate on two battery packs of
equal capacity. The mower will not operate on a single battery
pack, and If using different capacity battery packs, the smaller
capacity battery pack, when depleted, will cause the unit to
turn off
nOTE: For best results, make sure each battery pack is
 9 
fully charged.
To Install Battery Packs
1. Lift and hold the battery port cover 
battery ports 
 18 
(Fig. F) is removed from the
and place the grass collection
 13 
 14 
is not attached
 13 
and slide the mulching
 11 
up to expose the
 23 
.
 22 
rest on the

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xr dcmw564

Table of Contents