Electrical Connections; Figure 2 Pressure Connection; Figure 3 Typical I 2 C-Bus Network - GE DPS 5000 Series User Manual

Torque tighten the sensor in accordance with the system installation manual.
2.4

Electrical connections

The DPS 5000 series sensors employ a 4 wire I
Supply +
Serial data (SDA)
Serial clock (SCL)
Supply –
The sensor may be used standalone or as part of a network of compatible I
devices.
The DPS 5000 is intended for use within networks operated from a single supply
at a voltage within the range 2.7 V to 3.6 V. Operation outside these limits is not
guaranteed and may damage the sensor.
The sensor interface includes 2 reserved signals. These should be left open circuit
as connecting to these signals may result in incorrect sensor operation.
The electrical connections to the sensors are colour coded as shown in Table 1.
K0582 Revision B
Figure 2 Pressure connection
2 C-bus user electrical interface:
CAUTION
Figure 3
Typical I C-bus network
2
May 2015
2 C-bus
3