Toro 30365 Installation Instructions Manual page 4

Installing the Rear
Discharge Completion
Kit
62-Inch Decks Only
1. Loosely mount the new chambers to the
underside of the mower deck with 12 carriage
bolts (5/16 x 3/4 inch) and 12 nuts (5/16 inch).
Note:
Each chamber should have 4 sets of nuts
and bolts. Position the bolt heads inside the
mower deck. Position the chambers as shown
in Figure 2.
Note:
If a required mounting hole is not present
in the mower deck, use the new component
as a template to locate, mark, and drill the
holes (0.354-inch diameter). Only 4 holes per
chamber are used.
1. Left chamber
2. Center chamber
2. Loosely mount the left and right chambers to
the center chamber with 2 carriage bolts (5/16
x 3/4 inch) and 2 nuts (5/16 inch) as shown in
Figure 3.
Figure 2
3. Right chamber
1. Carriage bolt
3. Tighten all fasteners.
4. Mount the 2 support straps and the deflector
to the 2 rear angles with 8 carriage bolts (5/16
x 7/8 inch) and 8 nuts (5/16 inch) as shown in
Figure 3.
Note:
Position the bolt heads next to the rear
angle.
1. Rear angle
2. Carriage bolt with nut
g029606
5. Mount the rear angles with deflectors to the rear
mower deck with 8 carriage bolts (5/16 x 7/8
inch) and 8 nuts (5/16 inch) as shown in
4.
6. Mount the right foot shield to the top and side
of the mower deck with 3 carriage bolts (5/16
x 3/4 inch) and 3 nuts (5/16 inch) as shown in
Figure 5.
4
Figure 3
2. Nut
Figure 4
3. Support strap
4. Deflector
g029607
g029608
Figure