Removing Hard Disk Drives - NEC Express5800 Series User Manual

Chapter 2 Preparations
Mount the HDD trays that come with the HDD
cage from both sides of the 3.5-inch hard disk
drive. Mount the tray marked "A" on the left side,
and the tray marked "B" on the right side. Mount
the hard disk drive so that the flat face of the
hard disk drive faces downward.
Insert the hard disk drive attached to the tray
into the slot of the HDD cage.
When it is pushed to the end, it locks with a
click.
Connect the signal cable and the power cable to the hard disk drive. Use the signal cable that come
with the HDD cage. Use the power cable connected to the motherboard in advance. For details about
cable connection, see Chapter 2 (1.16.1 Internal interface cables).
Attach the front bezel and the side cover you removed in step 2.
Update the system configuration information by following procedure.
1) Connect the AC cord to the server, then push the power switch to power on.
2) If POST screen is indicated, press F2 key of the keyboard and enter BIOS setup screen.
3) The POWER switch is pressed and the power supply of the server is turned off.
4) Remove the AC cord from the server, and leave the AC power of the server off around 30 seconds.
5) Connect the AC cord to the server again, and push POWER switch in order to power on the server.

Removing hard disk drives

Remove the hard disk drives by using the following procedure.
See Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
To remove the side cover and the front bezel, see Chapter 2 (1.3 Removing the Side Cover and 1.4
Removing the Front Bezel).
Disconnect the power cable and signal cable from the hard disk drives.
68
Important
When disposing of the hard disk drives, follow the instructions described in
Chapter 1 (1.5 Transfer, movement, and disposal) in Safety Precautions and
Regulatory Notices.
Express5800/T110j-S, T110j-S (2nd-Gen) User's Guide
1. Installing Internal Optional Devices
A
B